How to flash and openline Myphone My28s
Download all:
1. FirmwareMy28s: Click Here
2. Upgrade Download Tool: Click Here
3. SPRD NPI USBDriver: Click Here
1.Open SPRD NPI USB Driver > Production Line Version >Choose "amd64" if you're using 64bits (choose x86 if you're using 32bits (After this steps install the driver that compatible in your PC)
2.Open Upgrade Download (You can locate it in the SPRD Upgrade Tool Folder)
3After you open Upgrade Download, Click LOAD PACKET then find the extracted folder of MyPhone_My28s_Openline_Firmware_v1 and click the pac file (Wait for a few seconds until the pac file will load)
4.After the pac file will load, click the START DOWNLOADING (Parang Arrow)
5.REMOVE your battery and insert it back
6.Hold Vol + and Vol - together, then connect the USB Cable into the PC.
7.If you can see "IN PROGRESS" in the Upgrade Download Tool, you can release the Vol +&-
8.It will flash and just wait for a few minutes (It takes 3 - 5 minutes, so be patience)
9.When the flashing is "PASSED" It means you made it
10.Remove your device in PC.
11.Remove Battery and Insert It Back
12.Go to RECOVERY MODE (Hold Power Button + Volume UP, Dapat una mo ma hold yung power button then hold mo din agad yung volume up
13.Do a Wipe Data/Factory Reset (After wiping, please REBOOT your device)?
14.Wait 5-10 minutes to boot your device. (may Kingroot na yan na naka install (Pre-Rooted kasi yung firmware kaya may root access kana agad. Open mo lang yung Kingroot, pwede ka na din mag debloat ng apps)
No comments